Interface USB Adapter

This USB adapter can only be used for programmable ABSIMA servos which are labeled SMART SERVO.

suitable for the following programmable Absima servos:
• ST23DBF Team Spec.
• ST50DBT Team Spec.
• LP16DBF Team Spec.
• LP20DBT Team Spec.
• ST18DBF Race Spec.
• ST40DBT Race Spec.
• LP15DBF Race Spec.
• LP19DBT Race Spec.
• LP34DBT Crawler Spec.
• ST62DBFT Crawler Spec.

System requirements1. Operating voltage: USB(5V/500mA).2. operating system: Windows XP/Windows Vista/Windows 7/Windows 8/Windows10 ( 32/64bit).3. application: Programmable ABSIMA servos with "SMART SERVO" labeling.


Parameter settings:

1. servo angle: Setting the servo rotation angle2. Servo neutral position: Setting the servo neutral position Note: If the transmitter turns to the neutral position and the servo does not

the servo does not remain in the corresponding position, you can change this value to adjust the servo horn. This

is equivalent to trimming the transmitter channel. 3. PWM power: Set the servo output power. The higher the power, the higher the servo torque and speed

The higher the power, the higher the servo torque and speed, but also the higher the power consumption.4. damping factor: Set the damping of the servo.5. sensitivity: Set the dead zone (sensitivity) of the servo.6. soft start: Slow recovery when the servo is switched on. As soon as the servo is switched on, it turns

gently to the position of the current input signal. Note: This function is used to prevent damage caused by incorrect installation

7. Reverse: Setting the normal and reverse rotation of the servo.8. Narrow Band: FUTABA SR mode9. SANWA SSR: SANWA SSR mode. Note: Activate this function to support SANWA SSR

high speed mode. The servo angle may not be accurate, it needs to be readjusted.

10. lost PPM protection: signal loss protection, there are three functions to choose from:

a. Enable: non-protection b. Maintain position: Remains in the position before signal loss c. Assume neutral position: Return to neutral position (1500uS position)11. Overload protection: set the servo stall protection. There are three levels, which are activated by checking the box: Stage 1: Set the start time and power value of the primary protection. Level 2: Set the start time and the power value of the secondary protection. Level 3: Set the start time and the power of the tertiary protection. Note: The left-hand side is used to set the start-up time of the protection, the right-hand side is used to set the output power after activation of the start-up protection.12. Servo information: Servo information. Including servo model, version date, firmware name. Servo name: Servo model Manufacture: Date of servo version Firmware: Servo firmware name

YOU CAN FIND THE NECESSARY SOFTWARE HERE:
Software Download