5mm PIN flash, 3Wx2, SHORT red

Miniaturization with high light output: the PIN 5mm series lights! In a complex manufacturing technique, high-performance LED chips are connected directly to an electrical cooling substrate and additionally bonded This means that an enormous light output can be generated and operated with a minimal chip surface of just 3x3mm. The scope of delivery includes four different light caps, the two round 5mm caps correspond to the familiar light-emitting diodes, but up to 100 times the known brightness with a beam angle >120°. The cooling and mounting pin on the back is only 3 mm in diameter and can be integrated very easily even in thin places in rudders or the thinnest tail units.

Technical data

• Electrical: 3Wx2 reference power,
• Voltage: 8(12)V, 0.25A
• Beam angle: >120°
• Luminous intensity: ~65 lumen RED
• Luminous intensity: ~150 lumen GREEN
• Luminous intensity: ~250 lumen WHITE
• Dimension: D5x20mm
• Weight: 2g (without cable)
• Operating voltage: 2S/8V or 3S/12V with additional resistor
• Cable length: 0.5m PTFE 0.14mm²
• Dimension: 5mm
• Design: Round
• Function: Navigation/position light

Scope of delivery

• LED with 0.5 m Teflon cable
• Pre-assembled series resistor for 2S
• 4 cap variants:
• 5 mm cylindrical (all-round light)
• 5 mm round, focusing
• 7 mm cylindrical (for gluing on)
• 5 mm profile-shaped (position light)


Installation instructions:
The design of the light contains an exposed LED chip, which is quite sensitive as a ceramic carrier. We additionally glue it to stabilize it mechanically, but very careful handling of the elements is always necessary until they are firmly installed in the model.
Warnings:


The flash light with 3W in x2 technology has an overwhelming peak output for this size, but may therefore only be operated in a flash or flashing pattern. Check the operating temperatures.