Warenkorb
Warenkorb
Warenkorb ist leer
ENG | DEU

Scorpion HK-4035 Motorwelle 5mm

SP-HK4035-SHAFT-5MM - Scorpion HK-4035 Motorwelle 5mm SP-HK4035-SHAFT-5MM
Abbildung kann von Originalware abweichen
Scorpion HK-4035 Motorwelle 5mm


The Scorpion HK-4035 motors are built with 8mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory repalcement shafts for all the HK-4035 series Scorpion Helicopter Motors. Our Motor Shaft Kits include an original equipment factory shaft with the setscrew keyways already cut, a new spacer washer, and a set of 2 retaining clips. This way, when one goes flying and bounces off the wall while you are trying to install it, never to be found again, you still have another one to use!

The shaft for the HK-4035 series motors measures 8mm in diameter, and is 86mm in long. The Stock HK-4035 motors have a 6mm output shaft end on them. The pinion end of this shaft is ground down to 5mm to allow the user to install 5mm pinion gears. The shaft kit will also fit other brushless motors that require a 5mm shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front houshing of the motor supported in a block of wood to prevent warping the front housing.
Bisher 41,60 €
39,00 €
inkl. MwSt.
zzgl. Versand
 Geringe Mengen verfügbar.
Lieferzeit ca. 1 bis 3 Tage*
Artikelnummer

SP-HK4035-SHAFT-5MM

Hersteller

Scorpion

Packungsgewicht0,03 Kg
EAN10004653
neu
Menge

Verfügbarkeit in meiner Filiale
Bitte loggen Sie sich zuerst ein, um diese Funktion nutzen zu können.