FPV Model YUN-I Brushless Gimbal (Alex Mos) für GoPro HERO 1/2/3
Neuste Firmware 2.1 


*** Features *** 

- zur Erstellung von wackelfreien Videoaufnahmen
- geringes Gewicht durch simplen Aufbau
- mit einstellbarer Vibrationsdämpfung
- Kompatibel mit GoPro HD HERO 1, 2, 3 und vergleichbaren Kameras



*** Technische Daten *** 

Abmessungen: 111x130x141mm
Ansteuerung: Gyro gesteuerte Brushlessmotoren
Traglast (max): ca. 200g
Betriebsspannung: 7,4V-14,4V (2-4S LiPo)
Dämpfergummis: 75x75mm
Abmessungen (LxBxH): 140x135x145mm
Gewicht: ca. 248g



*** FTD Driver ***

Setup_Windows_Driver_FTDI20828.exe
http://www.ftdichip.com/Drivers/VCP.htm



*** Firmware 2.1 ***

Firmware: SimpleBGC_2_1.enc.hex (74Kb 10.07.2013)

New option: skip gyro calibraion at startup. With this option checked, board starts working immediately after power ON.
New menu command and GUI button for manual gyro calibration
RC Map, RC Source moved to profiles. It allows to change RC control setting by switching profiles.
  (warning: after firmware upgrade, old RC Map setting will be lost)
RC YAW axis control may be  inverted now by specifying Min.angle > Max.angle, like for other axis (but this setting not used for limiting, just for inverting).
I2C errors monitoring: LED will blink when I2C error detected
New option: gyro high sensivity. It doubles sensivity of the gyro, that  equals to multiplying gains in the PID controller by 2.
It may be usefull for big DSLR cameras.
Translation to Chinese (thanks to Max) and Polish (thanks to Tomasz Ciemnoczulowski) language versions done.
The "Firmware Upgrade" tab in the GUI is working now and allows to upload a new firmware.



*** GUI ***

SimpleBGC_GUI_2_1.zip (5Mb 10.07.2013)
http://www.simplebgc.com/eng/